-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
LuckeyD's latest activity
-
LLuckeyD replied to the thread How to wire a power panel right to my mep 803a generator.Sir: Seems you get a lot of responses. Overwhelming so Ill be short in my war and peace. operators manual says L1 to L3 is your...
-
LLuckeyD replied to the thread MEP 007B fuel pump issues.Please read the manuals. Here is one thing I reported up the chain in about 2004. A unit had 007Bs that over revved, and others that...
-
LLuckeyD replied to the thread MEP-1050 Fault Code 3665.Oh. there is a light sequence of all those LEDs inside the DCS. You need a darker room to see all of them.
-
LLuckeyD replied to the thread MEP-1050 Fault Code 3665.They tried to show in the manual the part of the S12 that was sticking out . I was explained to that the ON is a BIT 1 in digital...
-
LLuckeyD replied to the thread MEP-1050 Fault Code 3665.Good Day: Manuals, please down load them, and then use them, both operators and maintenance versions. These in the forum you are...
-
LLuckeyD replied to the thread MEP-804A Voltage issues..Good day: Please do not start the gen anymore until you check out the regulator TR1 and AC Voltage adjust combinations. I attached a...
-
LLuckeyD replied to the thread S-250 AN/TSM-183 New Project.This was as i was retiring and becoming an ECU and Gen answer man. Hid away I found TM 11-4940-483-13&P dated 1 March 1989 with Change...
-
LLuckeyD replied to the thread Mep 803a No/Low Low Power Output.I am very glad you found your issue with AC output. I attached several PDF docs. I always use the DMM to set things as the gages are...
-
LLuckeyD replied to the thread MEP-804B putting out only 50HZ.Flop open the control panel by the half turn thumb screws on the top of the control panel. If the rope is busted fix it with any rope...