Recent content by MAZ537

Brake fluid (DOT3/4) works great and it will not harm the plastic.Only it will take way longer compared to paint stripper... Good luck

Sadly nothing yet...You can close it if you wish...

Awesome work so far! I can help you with troop seats located in Europe. Morlock motors should have them too... Good luck!

I will be able to copy all these linkage pieces to the company I am working at (it is casting/forging related) for very low cost but we need to have the pieces in hand to be able to copy them...Also shipping might be an issue from down there...

Thank you so much for your kind offer ! I have sent you a pm.

Thank you very much for the great info !!!

Hello guys, We have found a M35A2 with a MF LDT-465-D on it , sadly the whole alternator is missing along with its bracket... Can anyone please let me know the correct size(s) from the three bolts that secures the mount to the engine block and the two that secures the alternator to the mount...

Hello guys, I am trying to find the correct type of the starter and its bolts from an 1987 LDT 465-1D as both are missing from the engine... Thank you !!!

Hello guys, I am looking for one worm shaft , NSN is 3040-00-328-8862 part # 795462 Also for a brake drum , NSN 2530-00-740-9925 part # 7409925 And for some washers (x4) NSN 5310-00-740-9977 part # 7409977 Thank you

Hello guys, I am trying to find what size and thread are the correct bolts for the floor inspection cover ? Thank you!

Thank you all for your great help guys !!! Radiator in finally in !!! I have filled it with distilled water just for a test run and to try to remove the old cooland from the engine block... Down there we have G11 , G12 , G13 coolants , G11 is for older vehicles but I have no idea which brand to...

Small update ! I am trying to install the drain petcock to my radiator (both are NOS GM) but it does not want to fit all the way in (I have put wd-40 at the threads as well) , after 4 or 5 full turns it stops...Is this normal ? It does not have sit flush ? Thank you!

Hello guys, What is the best way to clean this surface rust ? There is also some in the axle as well... Also a diff cover that was removed with the old gasket fully intact can be re-used or it will leak ? Thank you!!!

Bosch are made in India and Delphi made in China...Both will work...NOS Bosch might be German made. Put the new (used) injectors on and then upload a video with the engine running !!!

Some pictures from your batteries and the wiring will be good...