-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Mogman's latest activity
-
Mogman replied to the thread M1152A1 rear axles 10K or 12K.So you are stuck with ether rebuilding the ones you have if they are not damaged or ponying up the big bucks. -
Mogman replied to the thread M1152A1 rear axles 10K or 12K.12K, a good hint is to look at your GVWR anything over 10.3K would be 12K unless someone changed them which is doubtful
-
Mogman replied to the thread OUT AND ABOUT WITH MY HMMWV.Ol Diggy Dog and I rolled on down to the beach just to check out the crowd, Diggy Dog had a great time barking at just about everyone...
-
-
Mogman replied to the thread 2006 M1097R1 Insurance in Texas.I just got coverage on a 2008 HMMWV through J C Taylor with a 13K stated value and 300/300K on the liability for around $325. I pay...
-
Mogman replied to the thread Lost nut in starter.You really cannot test the solenoid outside of the starter, all you can really do is check the coil for continuity. That piston the...
-
From your description my best guess is that the bolt in question went into the pivot for the Bendix. My first try would be to pick it up...
-
Fixed, bad batteries. So simple I feel bad making this whole post. Thanks for your help Mogman, much appreciated.
-
Mogman reacted to Gamble's post in the thread Where to connect additional electronic devices? with
Like.
For common off the shelf consumer electronics you can run switched power to an Orion 24v to 12v step down. Run the 12v power to a fused... -
If it "fell" in, it should "fall" out. BANG IT ON SOMETHING. Sometimes force works.
-
Mogman replied to the thread M1097A2 Random Limp Mode.Does the trans light always come on in run but not running? if so have you checked the codes?? there are codes that do not light the...
-
Mogman replied to the thread Lost nut in starter.Then you should be able to simply roll the starter over and shake the nut out unless you have put the starter in the vertical in which...
-
Mogman replied to the thread Lost nut in starter.There are no permanent magnets in a HMMWV starter. and the brushes cannot be removed without removing the end plate first, it is an old...
-
Mogman replied to the thread What have you done to your HMMWV today/lately.What are you going to do about the imbalance caused by the transmission TCM? TCMs do not like having switched 12V going to the...
-
Mogman reacted to spankybear's post in the thread What have you done to your HMMWV today/lately with Like.
Is the alternator some cheap china crap or is it a name brand? Also is it duel voltage>>
-
Mogman replied to the thread PN:22089 TIMING PROTRACTOR NSN:6675-01-247-2286.Again WHAT ARE YOU TRYING TO DO??? Do you have a pump test bench and trying to set up timing on a pump or are you trying to time a pump...
