Recent content by MRAD338

That’s what I thought, I’ll check that tonight.

This is the fault I get.

Still no joy! 😵‍💫

I will try that tonight! THanks

Roger That..

HI, There isn't a traditional pressure gage so i had to buy a manual gage to verify operating pressure, and it does have pressure physically. The monitor shows the low oil pressure as a fault prior to and after engine start. It has brand new batteries. I have not held the start lever over until...

Good morning, I have an 805B that runs great but will not produce power. The CRT says no oil pressure which I'm sure is causing the problem, but using a manual gauge it shows 65 psi. Any thoughts on this would be greatly appreciated. TIA

Guys, Thanks for all the info. I've read the TM's til I'm blue in the face, I wish I had the wiring diagram then I would have a better starting point. Oh, thanks for being positive and not throwing me under the bus for being new to this equipment. When you have a machine shop full of CNC's in...

Good Morning, I purchased an 805B gen set and have a question. It starts and runs great, has 13 hours on it but it shows no oil pressure when running, no rpm's either. It will not generate power though, I can only assume that the computer has an interlock to prevent the generator from loading...

Quick question here, was connecting my 24V to 12V setup over the holiday and only getting 20V to the converter. Do I need to take the ground directly to the battery? I ran the ground to the chassis. Thanks in advance.