-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
NDT's latest activity
-
NDT replied to the thread Oil pressure issue.Are you experiencing the no oil pressure issue while cranking or while briefly running? If only cranking, maybe that is not enough... -
NDT replied to the thread Oil pressure issue.I can’t remember, is there a oil pisser on the chain drive somewhere that you might have forgotten to put back?
-
NDT replied to the thread Battery cables.The box will have a conduit attached that will feed into a grommet hole in the cab floor. Positive cable goes from battery to starter...
-
NDT replied to the thread Hose - hydraulic fan clutch to solenoid issue.Hose should not be blocked with anything.
-
NDT replied to the thread New to the Forum.Welcome, yes this forum needs all the knowledge it can get, as every imaginable problem shows up here and some that nobody has imagined...
-
NDT replied to the thread Considering early 2000 LMTV for FD high water rescue work, question....General Truck Body Co of Houston TX makes this for LMTVs. If you open all the gear cases after fording and find no water intrusion...
-
-
NDT replied to the thread M 715 Kit Question.I would imagine the SECM would have a big ol hydraulic jack in lieu of the screw jack.
-
NDT replied to the thread Sounds like trouble.Check your driveshaft phasing. Check your hub spider gears. One or both is your problem.
-
NDT replied to the thread M 715 Kit Question.If you head over to the 715zone, someone has a picture posted of the correct one, and it does not look like yours.
-
I spent uncountable hours with those , about 3 years worth fueling tracks and M48's, M60's etc... The windup rope-start pumps were a...
-
NDT replied to the thread 1967 deuce rescue.......what to bring?.I drove a self tapping screw into a deuce air tank pin hole once, it's still there like 10 years later and holds air still.
-
This is a similar thread : https://www.steelsoldiers.com/threads/weight-limit-for-5-ton-axle.80210/ Pretty sure my M809 axles are...
-
NDT replied to the thread Gar Wood 3U615 winch.This seller I believe is the world's foremost expert on these winches, might be worth your while to reach out to them for a parts kit...
