-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
NDT's latest activity
-
NDT replied to the thread Best Way to Repair Bed and Floor Damage?.Y'all may not believe me but that aluminum alloy is un-straighten-able. -
NDT replied to the thread MEP 802A What happened here?.Possibly someone used jumper cables and hooked the negative cable to the chassis rather than the battery, which caused high amps to flow...
-
NDT replied to the thread Best Way to Repair Bed and Floor Damage?.Ugh. 3 ways. Replace floor by removing 1000 rivets. Swap body with someone “parting out” a truck. Plate over it with aluminum plate...
-
NDT replied to the thread Transmission Code 73.Before you condemn the TCM, it is possible that somewhere in the harness, one of the two wires going to the solenoid have chafed against...
-
NDT replied to the thread Transmission Code 73.Those manual shift kits are not a great idea. Word is they slam shift hard which might be fine for drag racing but not normal driving...
-
NDT replied to the thread Blackout light switch.That switch has been the same since it's introduction in 1950, still being made now by various mfgrs. With a multimeter you can verify...
-
NDT replied to the thread Transmission Code 73.Sounds like limp mode now. TCM very unhappy about something. I take it you are working with Supplement 7?
-
NDT replied to the thread Transmission Code 73.Does pin j or k have a short to ground?
-
From all I've read on here over the years, the cracking t-case in reverse is an issue with the T-1138 in the 939 5-tons and not with the...
-
NDT replied to the thread What is this and what does it do?.while cleaning the battery box I found .. | SteelSoldiers
-
NDT replied to the thread IH Military designation.Civilian trucks that uncle bought do not have M numbers for the most part. I think your axle is made by Coleman if it has a hemispheric...
-
NDT replied to the thread Battery Minder(s?) for LMTV M1078A1?.Great idea!!! BatteryMINDer 2012-AGM for agms, BatteryMINDer 12117 for old school, charge each 12 volt pair separate. Been running...
-
NDT replied to the thread XM816 Wrecker - Only Took Ten Years.I had bees in the bellhousing of a WWII TD-18 bulldozer. I too didn't want to kill them. What caused them to pack up and leave was me...
-
NDT replied to the thread AIR PRESSURE IN TIRES?.I would stay with 55 lbs unless you have 5 tons in the bed. 70 psi is to minimize sidewall flex at max GVW.
-
NDT replied to the thread M887 weight distribution plate.The dash data plate lists the GVW if I remember correctly. But no plates listed all the comprehensive dimensions like on the M38 plate.
