Recent content by noflyguy

Thanks guys for the info. Looks like ground thru panel and to fully test, put a load on the unit. I appreciate the dialog.(y)

I have the MEO003a unit in my shop and the ground rod for the unit is not available from within my shop. Do I need to have the unit grounded while starting up to test and warm up? If so, can I use the ground bar in my shop electric panel to ground the unit at the same time as I use the panel to...

I removed the injectors and had them tested. Diesel shop said they were real bad so I had them replace the nozzles. I have reinstalled the injectors and wonder how I should bleed air from lines. Can I loosen input line at injector and use prime switch to bleed air out? Thanks for your help.

Thanks for the vote of confidence :) I'll give it a shot.

My pump is an Ambac. I am sure I can get the pump off but I'm sure there are proper steps to make it easier. Do you have to take the blower housing off to get to the fuel shut-off solenoid? I have been unable to find anything on the TM section. What is the secret? You mentioned a TM that...

After reading your post and recalling how the unit responded over the last week or so, I believe my problem is the injection pump. From what I understand the pump is difficult to work on. I will be replacing the injector nozzles anyway, but what are my options at this point regarding the pump?

Initially had a problem with the pump not working after sitting a couple of years. Opened the delivery valve, tried to move plunger(?). Started up but nothing but smoke while running. Went back in delivery valve and spacer was torn. Got a new spacer for the seat. Started up still with a lot...

Thank you for the guidance.

Sounds like something I can do without much trouble. I found some fiber washers on ebay just in case I need them. I appreciate all your help. Is it possible to make sure the injector pump is working by disconnecting the lines and turn the engine over?

I'm a car guy and am not familiar with diesel. My current project is a 1934 Pontiac 4dr sedan restomod. I have the tools and ability to remove the injectors from the mep003a. In addition to the nozzles you recommended (which I ordered), are there any other parts needed to clean and repair the...

I have more questions about injectors. Can I just add them now? I specifically would like to ask RAY70 a question. Thanks.

Thanks for the info. I think I just figured out how to reply :)

Thank you sir! Glad I found a site where people know whats going on. I appreciate your help.