Recent content by phemer

Seems to be the consensus. We'll get it ordered and keep you guys posted! I believe the Regulator was causing the gennie to overcharge - which would trip the Overvoltage Cutout (OVCO). Manual says replace regulator and try again. I'll keep the group posted! Ironic how a few hours after I...

Amazing guys - much appreciated. I think I found my answer. Page 6, Chart 3b. Ohms from pins A to D = 2.2 (within spec). Follow onto Ohms from pins A to B = OL. Next step is to replace the regulator. Anyone have any weird exceptions or special cases that may apply before I throw another...

So - Similar issue I'd love some guidance on. My truck has the Niehoff N-1225-1 200A and a N3135 regulator. When I start the truck, charges as normal then creeps to overcharge (mid-red on gauge) then upon blipping throttle, spikes past red limit. 30 seconds of this, battery guage drops...

Hey Action, Pricing out what a 'ballistic' windshield project would cost me. Delamination appears to be an issue w/ most grey market items - which leads me to your comment. How would one remove lamination? I have a guy here in town who can apply 'ballistic' lamination, which would be a...

*compressor lol

Wow - Makes sense w/ the bracketry. In the event you do have to negotiate the issue of bent brackets, which i would view as a can of worms in trying to bend back correctly, I would suggest great care w/ figuring out exactly how much each accessory pulley needs to be spaced inward or outward...

Possibly bad picture? I assure you it’s correct.

The pulley was bent inward, shortening length of required belt and putting the Sanden pulley out of alignment or square w the rest of the pulleys - just barely. ALSO - SUCCESS!! Two washers in two of the upper mounting points, pushing the Sanden rearward. Two washers roughly = 1 rib. I...

Okay I believe I found the problem. I purchased/installed a Micro-V 25-081264. After 20 minutes, belt climbed rearward on the sandin pulley by 1 rib. The serpentine version I have is: I believe when my last belt tensioner blew out of the spring housing, the pulley flopped to the passenger...

Hey ACTION, The Sandin is the trouble pulley. I have never before seen this. I'll either reset the pulley to the correct rib or it will already be correct, but upon start, I'll notice the belt climb just one rib toward the cab (rearward) and ride up there. I'll kill the motor and it will...

I certainly don't intend on driving it this way, however, I'll reset and correct the belt placement then upon starting motor - climbs over that rib every single time. Belt seems stable once it climbs over that one rib - but still not correct. Still troubleshooting. If anyone else has any...

I've having the identical issue w/ the 6.5 1123 w/ reddot AC. Did the new belt (micro V 25 NAPA) fix the rib-jumping issue? Always placed correctly then upon start, immediately jumps a rib.

I would love to trade my 3/8 frames for your 5/8 frames. Pete

IDMACK3 - Great questions! Any trouble with adhesion? Pretty pricy and want to avoid failures. How meticulous were you in prepping? Zero problems w/ adhesion. My prepping included rotary sanding drill attachments - like most people would use on an angle grinder. I scuffed the CARC...

Hey TJones - GREAT STUFF!!!! I've sprayed 2gal of both the sound deadener and the ceramic thermal insulator product by Lizard Skin w/ their spray gun they sell. After developing a system for pouring more product from bucket to (tiny) spray-gun hopper (major pain in the butt), it went well! I...