Recent content by Purplerambler69

Thanks for the input guys. I was hoping to find somewhere a little closer to home, but will keep my options open. thanks!

Hello. Can anyone suggest a reputable truck garage or shop that I can trust my m925a1 to? Im in western Pa., zip code 16242. What I need done is to have Detroit Lockers installed in both of my rear diffs. I just don't have a place or sufficient equipment to tackle this myself. Any...

I recently had to replace my ppv. My local Napa wasn't able to help me even with the part numbers from this sites cross reference page (no big surprise). I then went to my local Mack garage. The ppv I bought there was built slightly different than the one I removed from the truck but with 1...

Thank for the info Patracy! After about 9 different phone calls I finally found a pair of new Detroit Locker units. Mark at Boyce Equipment told me he thought they had 4 of them left, after the 2 I ordered. A couple guys told me that they were going to try to get Eaton to start making units...

Can someone help me out please? Im trying to find a locking differential for my M925a1. No luck with Memphis Equipment or TNJ Murray. I called direct to Eaton and they said I needed to positively ID the axle housing. I gave them my model# which is M (I believe, hard to read) 1240rdax 2a. I...

Thanks for the input folks! Will check grounds asap. I think Warthog might have the best advice though! :wink:

Hello, I recently bought an M925a1. My fuel gauge isn't reading properly. Is reads full when the tank is full, but as I use fuel it doesn't really drop. It just kind of starts bouncing around. I've had it down to about 1/2 a tank of fuel and the gauge is bouncing between 3/4 and full. Does...