-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Ray70's latest activity
-
RRay70 replied to the thread MEP-802A questions.On the o-ring gasket, there are 2 of them, however in your picture the 2nd one is still inside the block. That tube is a short stub with...
-
RRay70 replied to the thread No AC output MEP-802A.Now I'd try a continuity test from VR 5 and 6 to F+ and F- on the exciter board ( item #10 ) as Kurt indicates in his chart above. If...
-
RRay70 replied to the thread MEP-802A questions.That strip is of little importance. You can go to Home Depot and get a roll of sticky back foam rubber tape and use that instead. They...
-
RRay70 replied to the thread MEP-002a possible Injector Pump Issues.Well, the good news is that since it was able to hold a full load in the past, to me that indicates the governor arm is most likely not...
-
RRay70 replied to the thread No AC output MEP-802A.For future reference you can go to the top of the forum page. You will see a bar with "Rules" "TM" and "Vendor Spotlight" listed...
-
RRay70 replied to the thread No AC output MEP-802A.Section 2-27 on pages 95/96
-
RIf the Fuse Mod fuse is good and you don't have power the the outlet then you need to perform the AC Voltage Regulator test. Post up...
-
RRay70 replied to the thread MEP-802A questions.If you can't get the gasket in time, you can also purchase a 12"x12" square of gasket material from your local auto parts store and cut...
-
RRay70 replied to the thread No AC output MEP-802A.Take the fuse out of the holder and test it. it is a slow blow fuse, but there is no such thing as a time delay reset fuse. Remove it...
-
RRay70 replied to the thread 1969 MEP 10K Generator.$48!? Does that particular TM weigh 40 lbs. or something? it should qualify for USPS media mail for like $5, sounds like someone is...
-
RRay70 replied to the thread No AC output MEP-802A.Ah, I see... I read where you said Hz at 60 and everything else was working and I assumed that meant the outlet was also working...
-
RRay70 replied to the thread MEP-802A questions.Make sure you get every last speck of sand out of the thermostat housing and the water passages. Also might want to change the gasket...
-
RRay70 replied to the thread No AC output MEP-802A.Didn't you already say the HZ meter and outlet were working? if so you are making power. I've just skimmed over this whole thread...
-
RRay70 replied to the thread MEP-002a possible Injector Pump Issues.YUP, just be careful, the center of the filter is usually the downstream / output side, so anything you pour in will go unfiltered into...
-
RRay70 replied to the thread MEP-002a possible Injector Pump Issues.Before pulling the injector, take 2 minutes and load it until it bogs, the push up on the linkage and see if engine revs up or not. That...
