Recent content by RClark13

Did you do any homework on replacement gauge? I've had horrible luck with "Military" aftermarket sellers/re-sellers. Ordered on from one of the big names,it was too small, got the usual "there is only one for all MEP-802A, you must have a different engine" response. Saw a few on ebay that say...

I wll double check alignment, the outer rib just came off, it kept running after that. I did check fit on all 3 pullies, seemed ok. verified belt width with MIL part number and Gates. Thanks for the input!

I am having issues keeping the Micro V Belt on my Generator. Unit had a water pump shaft failure, bought a kit from HQ Motor Service, not sure if that was the initial mistake, Kit came with a belt that was 1.5" short, returned it and found a Gates 5040355 (K040355). Ran unit for approx 30...

thank you!

Thanks Kurt, I'm trying to contact them, being new here, I am awaiting admin to facilitate the conversation. also fishing for info on the DN2W vs DN2M, not sure if there are any differences. I have ordered hoses from a few vendors, all claiming there is only one style, yet none fit my lower, so...

I have an MEP-802A with an Onan DN2W engine. Can anyone tell me if the W is a model change? Having trouble locating lower radiator hose for this, I've tried a few vendors and they are either completely wrong, or, correct shape, but 1" ends, mine uses 1-1/4" on both ends. All of the listings I...