-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Recent content by rjag623
-
R
Class IV Hitch...Done.
Thanks a bunch! Ron- rjag623
- Post #18
- Forum: Deuce Modification and Hot-Rodding
-
R
Class IV Hitch...Done.
You wouldn't have a schematic of the wiring? It would make the project much simpler...not wanting to re-invent the wheel and all that. Looks good! Ron- rjag623
- Post #11
- Forum: Deuce Modification and Hot-Rodding
-
R
Fuel nozzle leak
RE: manifold heater O-rings replacement I took the nozzle off today, it was a bear to take down to visualize the o-ring. I only see one O ring on the cover held in place by the snap ring. Will look for a new o-ring at the hardware store tomorrow. I will post size if I can find the correct... -
R
Fuel nozzle leak
Pics would help a bunch, and if anyone has an extra... Ron -
R
Fuel nozzle leak
I have the same problem, anyone know where I can buy a new flame heater nozzle? -
R
Another deuce recovery success
Thanks for the advice! I will do the simple things first. I noticed a leaky rear axle seal also. The driver's seat appears new, not faded etc. ride wasn't too bad but my buddy Jim drove half the way. -
R
Another deuce recovery success
Picked up the deuce in Sante Fe two days ago. Bruce was very good to work with, had the deuce running and the M105 being pulled out of the yard as I arrived. My buddy Jim and I took the deuce into Sante Fe for fuel and a good pre-trip inspection. All the fluids were good, oil was good...