-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Ronmar's latest activity
-
RRonmar replied to the thread Two Batteries Instead of Four - Issues?.Ether itself is not the problem, as it is simply a combustible fuel with a lower ignition temperature than the diesel that is also being...
-
RRonmar replied to the thread Two Batteries Instead of Four - Issues?.The truck was saddled with this monster 4 battery bank to meet some cold crank mil-spec at a very low temp. Unfortunately the bright...
-
RRonmar replied to the thread Two Batteries Instead of Four - Issues?.None at all. Cat specced a pair of group 31 batts for these engines, and that is really all they need. A pair of group 27’s would also...
-
RRonmar replied to the thread Subframe question.I took a few minutes and looked back at their build series. They show the subframe assembly in their 2nd build video. It is a 4 point...
-
RRonmar replied to the thread CTIS issues.Cool, you found it! This has been a fairly common issue I have helped troubleshoot. Probably a mud dauber or some other insect...
-
RI would like to thank everyone for their assistance, I disconnected the vent line at the PCU and the system is working normally...
-
RRonmar reacted to Aviator4x4's post in the thread M1078A1 "Pandora" Build | 2024-??? | ***Picture Heavy*** with
Like.
Here are some pictures of the fitment of the commercially available seal drivers. It's close... but almost completely ineffective since... -
RRonmar reacted to Aviator4x4's post in the thread M1078A1 "Pandora" Build | 2024-??? | ***Picture Heavy*** with Haha.
Started reinstalling hubs and EcoHubs today ! The seal drivers available on Amazon/Napa aren't an exact fit, but the TMs have diagrams...
-
RBeen busy but made progress on this today. Pulled the reg and pumped the primer, no pressure built up, just fuel pouring out of the...
-
RRonmar replied to the thread Transmission-Related Questions.It goes out thru the bottom. In one of the manuals there are specs for a lifting jig to do it with a crane(bed removed). i am having...
-
RI can only speak to the OEM M1079 captured spring system on my hab. I live on the coast in S.Tx and it blows 25mph on a normal day...
-
RRonmar replied to the thread Cruise Control?.OOPS, I screwed that up. I was thinking it was 36, but found one of my other posts on the subject indicating 26. I think I typed that...
-
RRonmar replied to the thread Cruise Control?.I could always put a freq counter on it and drive to be certain of the final output, but on my A0 it does sense a 36 tooth spinning...
-
RRonmar replied to the thread Subframe question.Yea the subframe is supposed to allow the box to move when the frame twists. The thing about captured spring is that they WILL impart...
-
RRonmar replied to the thread Cruise Control?.Ok with stock wheels and 2:1 hubs(7.8:1 total ratio, at ~60MPH the driveshaft is spinning an insane 3375 RPM. If I recall the output...