-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Ronmar's latest activity
-
RRonmar replied to the thread LMTV Driver Door Window Glass Help.No I do not, and I forget who I dealt with there over the phone. There is a thread in here that I started when I put in my omni...
-
RRonmar replied to the thread Cruise Control?.I am going to go a little more sophisticated, air cylinder and solenoid valve to the brake switch. When you touch the Brake pedal, the...
-
RMeh, dash throttle lever and a bungee cord. /done ;p
-
RIve considered an old school Universal one with Brake Pedal switch and a servo motor and you glue a magnet somewhere or pick up a signal...
-
ROK, I've got it off! Success! It was the forward slack adjuster. It was frozen and had the lower brake shoe much too tight. I...
-
RRonmar replied to the thread Subframe question.Yep, and if the tubular frame is strong enough, like the tube and fabric airplane, the skin can be a lot of things. if the frame...
-
RRonmar replied to the thread Subframe question.Stressed skin as in the skin carries part of the structural load. An old school frame and fabric aircraft has a frame structure that...
-
RRonmar replied to the thread LMTV Driver Door Window Glass Help.I got one from Omni Glass and paint in Oshkosh WI…
-
RRonmar replied to the thread Two Batteries Instead of Four - Issues?.Ether itself is not the problem, as it is simply a combustible fuel with a lower ignition temperature than the diesel that is also being...
-
RRonmar replied to the thread Two Batteries Instead of Four - Issues?.The truck was saddled with this monster 4 battery bank to meet some cold crank mil-spec at a very low temp. Unfortunately the bright...
-
RRonmar replied to the thread Two Batteries Instead of Four - Issues?.None at all. Cat specced a pair of group 31 batts for these engines, and that is really all they need. A pair of group 27’s would also...
-
RRonmar replied to the thread Subframe question.I took a few minutes and looked back at their build series. They show the subframe assembly in their 2nd build video. It is a 4 point...
-
RRonmar replied to the thread CTIS issues.Cool, you found it! This has been a fairly common issue I have helped troubleshoot. Probably a mud dauber or some other insect...
-
RI would like to thank everyone for their assistance, I disconnected the vent line at the PCU and the system is working normally...
-
RRonmar reacted to Aviator4x4's post in the thread M1078A1 "Pandora" Build | 2024-??? | ***Picture Heavy*** with
Like.
Here are some pictures of the fitment of the commercially available seal drivers. It's close... but almost completely ineffective since...