-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Scoobyshep's latest activity
-
Scoobyshep replied to the thread MEP-114A GPU.The frequency gauge should be before the output contactor so it should indicator frequency even if the main contactor is off. I would... -
Scoobyshep replied to the thread MEP-114A GPU.Of all the sets I've worked on that had that model of fuel pump I think I've only had one that was not salvageable. I recently cleaned...
-
Scoobyshep replied to the thread MEP-114A GPU.There are off the shelf options available that will function however tearing the existing pumps apart and cleaning them cost you maybe a...
-
Scoobyshep replied to the thread MEP-114A GPU.Well it's good to keep in mind the overall list of things to do first things first we need to get the engine stable Sent from my...
-
Scoobyshep replied to the thread MEP-114A GPU.I'd say that's the case Sent from my SM-S908U using Tapatalk
-
Scoobyshep replied to the thread MEP-114A GPU.But exciting! In a duck and cover kind of way
-
Scoobyshep replied to the thread MEP-114A GPU.I can imagine, motors running at 6.667x rated speed
-
Scoobyshep replied to the thread MEP-114A GPU.Damnit I fat fingered it..
-
Scoobyshep replied to the thread MEP-114A GPU.Ok. Thanks for clarifying, engine wise not much changes but electrically it makes a difference. As Guy pointed out, this is not a 005a...
-
Scoobyshep replied to the thread MEP-114A GPU.Do something quick for us to help eliminate further confusion. Look at your hertz gauge. What's it's reading range? Around 50-60 or...
-
Scoobyshep replied to the thread MEP-114A GPU.For everyone's sanity, the radiator is the front and the control panel is the rear. These fuel pumps are extremely simple and I...
-
Scoobyshep replied to the thread MEP-114A GPU.Now that I've had more caffeine, there are 2 fuel pumps plumbed in series. Then the water seperator and primary filter. This goes...
-
Scoobyshep replied to the thread MEP-114A GPU.Low oil will come on when the unit is placed in run (no pressure). After you start it flopping the reset switch should reset the fault...
-
Scoobyshep replied to the thread MEP-1050 3 Phase To Single Phase.No. Ct stands for current transformer (or transducer depending on circumstances). Ct4 here is monitoring the current for the convenience...
-
Scoobyshep replied to the thread MEP-1050 3 Phase To Single Phase.Only for current draw. There should be something metering the voltage output as well Sent from my SM-S908U using Tapatalk