-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
thoner7's latest activity
-
thoner7 replied to the thread A/C Diagnostic help.I installed my valve. No cable yet. But it seems to let fluid through, even when shut. I stupidly ordered thenone At idle, My front... -
I noticed something very similar to that on mine too.
-
I think it is normal since the push pull cable will only activate the valve a 1/4 turn. Some have a "stop" detent built into the valve...
-
thoner7 replied to the thread A/C Diagnostic help.I received my valve in the mail. Is it normal for the thing to go past its “full open” and then restrict flow again? One pic is the...
-
-
thoner7 replied to the thread A/C Diagnostic help.I’m pretty sure there are clamps there already. Holding in the valve that went bad.
-
thoner7 reacted to spankybear's post in the thread Hot & Cold air simultaneously from fron A/C vents with
Like.
I used the one from rock auto on my M997A2 and it work fine. It looks just like what was replaced. You can use this on the A/C trucks... -
thoner7 replied to the thread Hot & Cold air simultaneously from fron A/C vents.Did that one work with the cable? I still need to replace mine with the manual cable style. someone else had tried a cheaper valve...
-
thoner7 replied to the thread Hot & Cold air simultaneously from fron A/C vents.Read the posts from here on. There’s a 35$ ball valve replacement too...
-
thoner7 replied to the thread M1167 A/C trouble shooting.Im attaching an Air Conditioning manual that I found in another thread. I have either insufficient or intermittent cooling. I...
-
thoner7 replied to the thread M1167 A/C trouble shooting.Would a failed thermostat switch cause the delayed/ intermittent cooling I experienced?
-
thoner7 replied to the thread REV overheating - normal?.Updating on my repair to help future readers: I got the radiator out and the fan clutch swapped. After cruising on the highway in 80+...
-
thoner7 replied to the thread M1167 A/C trouble shooting.update on my 1165 AC It was 80+ today so I took the truck out to the store. The AC didnt work, at first. I let it blow air for a...
-
thoner7 replied to the thread M1167 A/C trouble shooting.Compressor works, both condenser fans run. I had cold air out the front and back this morning (I think, it was 50* this am but air was...
-
thoner7 replied to the thread M1167 A/C trouble shooting.Welp, they put in the gas this morning, again. It was blowing cold when I left, but it was only about 50 out, so take that for what...
-
thoner7 replied to the thread A/C Diagnostic help.Just to confirm I’m doing this right - the little C shaped piece turns the valve? Forward is AC and back is heat? My truck has heat...
-
