Recent content by Vapor Trail

I am interested in the side marker blinker system they sell. It only works for 24 volt systems so they very generously offered to design one just for my rig. I can’t believe the government would design a vehicle where you can’t see the turn signals at all from the side

I just caught them at an unusual time because the website was down for upgrades. He got in touch with me right away and was very helpful and generous with his time. All good now

Thanks!

What's the deal with Camotek Systems? They show recent activity on their facebook page but their website doesn't work, there's no phone number, and they don't respond to FB messages.

Yes, while there was no fluid in there I though I should clean it and put it back together but I think I'll leave it alone. Most of the electrical brake sensors with the arm on them for the pedal require extra wiring because there normally closed so i think I need to find somewhere in the...

OK, thanks for straightening me out mogman. Can a person take that all apart and clean it?

When you say "in balance" if mine is reading closed does that mean it needs to be adjusted? Also I don't think it flips back and forth every brake push so that can't be my brake light trigger.

So that won't help me then. I just saw somewhere else that it's dry in there so I don't think that spot will help me.

Does anyone know if I can get a brake pressure reading there and what the thread pitch might be. It’s probably a brake pressure sensor but there’s no fluid in the system and it’s reading closed with a meter so it’ll be a lot easier to wire into my harness with a very common normally open...

Also, I got longer shocks from someone on here, I think American Humvee or something. THe guy who sells those springs. I had to put limiting straps on to keep the axles from binding and theyre still bound up now I think. You can only go 1/2" or so more than stock

Trying to figure this suspension out is so random. I'm not sure how you are running uncut Armada springs in the front with 2" spacers as I have cut Armada springs and no spacers and I'm sitting 6" high with my frame at 24". I'm going to make taller upper spring perches but I don't know how...

It's all been a challenge. I'm working on three years but it's almost done. Literally can spend 5 hours researching one fitting you need like I did today. I have a build thread on here that might help. Several others are doing it too and there's some stuff on Youtube but most of the time the...

ok thanks, I didn't know that. I ordered one new one but one has to be a custom length so I'll do that. Thanks again.

If I'm going to make my own power steering hoses for the high pressure side what would be the best diameter, 6 AN, 8 AN, or 10 AN?

Does anyone know how high the center frame under the front and rear differentials should be off the ground in the stock configuration? I'm trying to see how much lift I've added.