Recent content by WillettRun

To follow up, The generator governor issue was simply a matter of re-landing terminal one.

Thank you so much!

Excellent, thank you! I have power. I can finally finish welding up the bison pen! Now, to the next question. I only seem to be able to sweep 43-52 hz in terms of frequency, with the select switch in 60hz. What should I check for there?

To clarify, what does the voltage regulator terminal expect to see in terms of voltage, resistance (or ground) ?

I have verified all to be correct. I do not have the original gauge, but have connected the oil pressure m7 wire to the signal wire going to the gauge.

1. 120VAC 2. 11VDC It should be noted that with s1 in start, the gen produces voltage.

Many thanks, I greatly appreciate it,

Yarp. I work in Lenexa, KS.

Thank you for replying, Kurt. I will go and perform these tests and write back.

What should I check for next? I did the install according to the guide and did everything necessary. I do not know where to go from here. I only see 20v AC or so on the gauge.