Recent content by Zonecone

I have available new outboard C.V. Cages and correct pop up wires. Check your cages for cracks , I think the cracks pictured were caused by hammer blows .this joint has had numerous axles.:

i understand the weakest link theory but by looking at the outboard cv it can handle it the inboard on is strange because it is a weldment.i have seen one of these vehicles only the parts.the diff unit I bet is an 8.8 ford unit by the spline size.if you leave # I will call,or you can call me. Thanks

Making new shafts out of 1040 material would defeat the purpose .iwould make them out of e4340 if there was some numbers.

I make axles for all kind of off road race cars. These are made in house ,heatreated ,straighten and then polished. maybe over kill but looking at the stock axle it looks like a good idea. I have also I.D. The outboard C.V. And have a source for pants .by looking at the outer joints they have...

Let axle shafts

Just completed first run of properly designed axle shafts. Made out of 300 m material ,heatreated and polished ! I am working on c.v. Cages and boot for new axle diameter . Will post pictures !