Recent content by zxmedic

Well someone in Oregon got rooked buying this thing. Sent from my LG-H812 using Tapatalk

Sorry for the late reply here are a few more pics of the hiab. On my 813 Sent from my LG-H812 using Tapatalk

Here are a couple more pics. Of my 813 Sent from my LG-H812 using Tapatalk

I have the same problem i had to cut some of the cross suport out after i ripped it off the bed. My plans is to use 6" channel and raise the bed. Sent from my LG-H812 using Tapatalk

If you mean my Little hay bale mover. Thats a Canadian M813 fitted with a Hiab the engineering units used these. Sent from my LG-H812 using Tapatalk

Moved some small hay bales this week. Sent from my LG-H812 using Tapatalk

So install is complete in the end the reverse issue was that the Transmission shift fork was out of the collar locking it in reverse. Good i didnt try to drive it. Sent from my LG-H812 using Tapatalk

Thanks for the reply it was my own failure. Being the 2 pressure plates are so differemt .I did remove the bolts after installing the new pressure plates. Now my issue is the Transmission only seems to operate in reverse the shifter goes into 1 2 3 4 5 detent and only partially into reverse. If...

So I am just in the middle of new transmission and clutch install on my M813 my truck seems to have had a aftermarket pressure plate installed . Ive had the flywheel resurfaced i went to install the new pressure plate and friction disc and there is barely any grip. Using the information in the...

I did do a search. Thank you Sent from my LG-H812 using Tapatalk

ST997*4910-00-150-5810 2-70* does anyone have this tool available seal driver Sent from my LG-H812 using Tapatalk

So about to do a rear main seal and speedi sleeve on my 813 who's done one did you find a way with out the install tool?. If you took the rear of the engine off how did you deal with the run out test on the crank after re install . any help would be great cheers. Sent from my LG-H812 using...

The other possibility is its leaking into the airpack. For a few extra dollars if you havent already buy the brake fluid reservoir so you can eyeball your level without having to pop the cap all the time .I found mine on ebay . Sent from my LG-H812 using Tapatalk

Its possible the brake fluid is contaminated from a previous owner. You need to find the source of your leak weather its into your airpack or one of your wheel cylinders. Sent from my LG-H812 using Tapatalk

I am not sure what these are torqued to but on my hemtt rims there at 500 ft lbs i have to use a torque multiplier to loosen them or a quilty truck 1 inch impact. Sent from my LG-H812 using Tapatalk