-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
M1031 Apecs 4500 controller programming
- Thread starter deank
- Start date
Skinny
Well-known member
- 2,132
- 492
- 83
- Location
- Portsmouth, NH
No problem, glad I could help! Keep those M1031s alive.
Hello all.
I managed to get my generator wired up today. Then I re-installed the PTO.
Everything works perfectly!
If anyone is trying to upgrade their M1031 to an APECS4500 controller, I now can program the controller from a known good calibration.
When I turned the system on, it took a moment for the controller to seek the correct RPM, after that, eveything works great.
I make no warranty of the file, use at your own risk. I am using it on my truck.
I will charge $0.00 to program your controller.
If you wish to do so, send me a message to arrange it.
If you send me your controller with prepaid return shipping we can get it done.
I will send it back with a wiring diagram from the creator of this upgrade. I intend to change the wiring on mine to re-incorporate the safety switches and add a low oil pressure cutoff.
I managed to get my generator wired up today. Then I re-installed the PTO.
Everything works perfectly!
If anyone is trying to upgrade their M1031 to an APECS4500 controller, I now can program the controller from a known good calibration.
When I turned the system on, it took a moment for the controller to seek the correct RPM, after that, eveything works great.
I make no warranty of the file, use at your own risk. I am using it on my truck.
I will charge $0.00 to program your controller.
If you wish to do so, send me a message to arrange it.
If you send me your controller with prepaid return shipping we can get it done.
I will send it back with a wiring diagram from the creator of this upgrade. I intend to change the wiring on mine to re-incorporate the safety switches and add a low oil pressure cutoff.
Last edited: