Search results

It is the fuel solenoid that is shutting off the unit.

I am having some issues with my Mep002a. I started it and it would run for about 20 minutes and dies each time. I bypassed the oil switch and that didn't solve the problem. I attempted to remove the temperature switch to inspect and clean it up and it broke off. So I jumped the wires and now the...

I am looking for a CVT1 for my Mep200a. Where can I find one at a good price?

I am looking for replacement CR Diodes (Rotating diodes) for my MEP002A. I have not been able to locate them anywhere and I was wondering if anyone on here had a lead. Thanks

I just re placed a defective VR on a MEP 0002A and now, with the new one, I am getting excessive voltage between 260 and 300vlt on a 120/220 setting. I was wondering what could have possible gone wrong. When I start the generator, before it is operating at 1800 rpm, I get 124vlt and then once it...

But if I do not flash the field pf my MEP 002 for a few second, it will not produce AC output. Do you have an idea what the problem might be.

Why do I have to flash my generator every time I start it to make it start producing power?

Hi, I just replaced the bridge rectifier on my ME 002A and upon installing the new one, I noticed that the resistor on the bridge rectifier was starting to get really hot. So, I took off the battery terminal to cut off the DC power to the system. Later when I put the terminal back up, I did not...

Where is (S7) located? I have looked for it and I cannot find it. I can see it on the schematics but I have hunted for it to no avail. Also, the starter has been stocking and sometimes it takes a little knock with a wrench to get it to work---could that related to the problem?

I have replaced the components of the bridge rectifier and the resistor got really hot within seconds, again. When I first re-installed the part, I got voltage and rpm but when I noticed the resistor getting hot, I turned the unit off. Upon restarting it, I got no voltage. I wonder what is...

I rebuild the board with new diodes and 20 W 56 OHM resistor and I got voltage and RPM, but the resistor started burning again. I turned the generator off and turned it back on with no out put. I am assuming that the bridge rectifier is fried again. I am not sure what is causing this. Any input...

Do you think this FROM Radio shack would work?:10W056 56 OHMS CERMET POWER WIREWOUND RESISTOR

Do you know what type of resistor goes on the bridge rectifier for MEP 002A?

Thanks a whole lot. Would you by any chance know the type of resistor that I need for the bridge rectifier?

My MEP 002A just stop producing electricity even though the engine was running fine. upon investigating the problem, I found out that the bridge is completely burned. Now my question is; what would cause the part to burn and where can I buy a use and new one? Thanks.

Also what type of oil does the MEP 002A uses?

Thanks, I just verified and the one on my Gen. is the type 1.

I don't know type I have. Is there a way to find out?

I have a MEP 002A that won't start until I tap the back of the starter with a wrench. Any suggestion on what the problem might be and how to fix it? Also the Herz gauge does not work. Thanks

My generator bugs down under 70% of its load capacity. Any idea of what I should do to figure out the issue?