Search results

I just looked at it a little today,the screens must have been gelled up,took the line off to pump put little anti gel in it and it pumped good with the battle switch on still does not pump with primer switch but the day tank may be full didn't really check that. started the gen up and it ran for...

thanks for the reply, I dont have a fuel gauge it is missing,it is too cold right now to look into it right now, the fuel pump does run with battle sw on but will not run with primer switch. the fuel pump may be bad also because the fuel just dribbles out when the pump is running.

I have a mep-005 and the low fuel light came on while running so i hit the primer switch and nothing happened, then fliped the battle switch and fuel pump runs, is there a fuse or something to look for? When the fuel pump does run on battle it still wont push fuel out the line just dribbles...

does anybody have a part # for a mep 005 starter selonoid or where to get one reasonable?

thanks for the replies, the A/C itself would be 30A total amps would be 50-60A, I was going to use alum. overhead which would dissipate the heat better. Though about using 2 transformers also, but still wondered how big wire between them and the cost of them. Cant move the genny closer...

Trying to run house trailer and office trailer; I was wondering if anyone knows if I can run wires 600' to run lights,ref,computer,A/C(aproxx 30A), and what size wire should I run? Also if I am using a generator for main power(no utilities near by) should i drive a ground rod and bond the neut...

thanks for the replies, how hard is it to put a precision kit on? I would like to use my computer and tv's would that hurt them?

I just got a mep-005 genset and was playing around with it a little and when I set the rpm to adjust frequency after it ran for 10 min it raised up to 62 when I readjusted it down then when I put a load on it it went from 57 to 61 back and forth. the feq adjust knob below the gauge does not seem...