Search results

A full floater. You have 3/4 axles in there. The good thing is you will probably get more top speed and less rpm.

go to post 7

Its weird how this post showed up. I went look at this guys m1008 today and noticed It had a 10 bolt. I did not have the heart to tell him about it. He paid 5k for it.

You could just replace them but personally I would not even put 5 dollars into a set of non 1 tons. (thats just me) Im hard on everything. If you look at the rear end does something stick out like 3" in the center of the rim? (has bolts)

someone robbed the dana 60 and put in a 3/4 ton axle. I'm betting they did the same to the rear.

Sounds like some one made a 3/4 ton and robbed the axles. Easiest way is count the u bolts if you are unsure.

Mine shifts a 2 around that speed. Your engine must be screaming.

You need to buy dually hubs for the front. Just unbolt everything like your doing a brake job and put on the DRW hubs then reassemble.

radiators are the same. The easiest way to convert to dually is to switch out you hubs. If you want to trade SRW for DRW let me know.

Is there any special tools to clean the contacts on a fuse panel? I am starting to have problems with some stuff in there. I'm loosing lights and not realizing it until later.

I put3.5's in the front and bought Civi rear brackets and put some pioneers in them

A lot of people ( bus company) does not know the elec system in CUCV's. You are better off reading up on old posts and fixing it yourself.

I did the same thing to my truck. I could not tell if my starter was 12v or 24v. It happened to be 12v. I hooked up 24v to a 12v starter and I had to run and rip off the battery connection. If I were you this is what I would do. leave it 24v. Find a OEM starter and have it rebuilt. Replace/...

i need some also. I have always like pioneer stuff.

Try it . If it works great, but if it doesn't that would be a pain to do it twice.

I think you need a new flex plate gas job and a new torque converter. That's what I had to do. My friend at the tranny place told me they arnt interchanageable

worst places floor boards, rockers, tail gate, rear floor. Hold out until you get a rust free one. Your in AL there should be plenty

I think for that kind of money I would hold out for a rust free one.

Both of your answers are in the FAQ section. You may want to read the whole thing. Lots of good info.

I did on my m1008