Search results

m923a2 fail safe warning control module 11669142 i just replace this module because i had no warning lights or low air buzzer. a few hours of driving and i have the same problem again anyone have any ideas? and way to test the module?

Does anyone know if you can register an m151 in California?

could anyone tell me if this is an evens fan clutch i need to rebuild it and saw a kit on eastern surplus and want to make sure im getting the right one?

does anyone have a diagram for the fuel tank. for the life of me i can find it in the tm. i need to know what the pick-up tube goes in to at the bottom of the tank.

I've change both fuel filters on m m923a2 before with no issue. this time i removed the tank and cleaned all the gunk out before changer the filters. i topped off both filters and pumped till fuel came out of the bleed screw. truck started and ran fine for a few minutes then died. i...

My fan actuator is leaking air from the smaller hole on the end cap. i cleaned and lubed it but still leaks air. i was wondering if it should have an o ring. it did not have one when i took the cap off?

forgive my ignorance - what engine oil weight do i use for my 923a2?

my m923a2 had air escaping from the air dyer took it apart and decided not to rebuild just replace. replaced and all was fine for a few mile and it started leaking out of the same blow out valve. i am at a loss any ideas out there? i used a punch to press the valve closed a virew time...

the last couple time a started the truck, it took a long time to air up. The last time it would not air up past about 25 and now not at all. I soaped everthing i could with soap but no luck. i replace the governor and did a complete service/rebuild on the air dryer. Still would not air...

Can anyone help me finding the part # for the #6 tank drain hose. for the life of me i cant find it. this is the line that runs from the air tank on the drivers side to the #2 or bottom drain valves on the pass. side. thanks ....mike

just stated to hear a low clunking/rattling noise at the front of my 5 tons engine. i can only hear it when its idling. Could this be the fan clutch or vibration dampener going bad?? Any ideas??