Search results

This weekend job... This patches are made with thick metal. Started to test this one... Allready with stainless steel nuts and with a bump, as original, taken by the surviver part on the other side. Presume that will be to give some rigidity.

More coffee:mrgreen: Let's see...

On the front corner, this part will be all done, inclusive the small box on there.

New patch... Bad repair in the past... And many loose rust on there...

Let's go to another place... Up front now... Need to repair this zone to put the side panel... This two parts are joint by a third small one, that need also a replace.

Cleaned looks other thing... Some grid still to make... And with provisory zinc paint... 8 work days only on this aerea...

But to put her on place I need to finish this one first... This part will be above the box...

Allmost there...

The box from the other side was used as template...

Started to make the box that should be in this zone... Allmost there...

Started to make the bump as original... But with the car up side down is difficult, and also with the supports that I welded...

Started to clean the several original and non original metal parts on this zone.

Seat bell screw zone... of the rear seat... Very rusty... No words for this...

First part of the outside metal at place...

Dark Hammerite... by paintbrush... Hammerite preto... After the paint, will have wax for cavities...

More work done... Let's finish this zone... Sanded and protecting yhe interior... ... as also the out panel....

And finally the patch...

At back again... More cleaning...

Finally out and also the stearing...

They cut the metal and also the cover of the wires... Allmost get them...