Search results

If your going to do lockers, Get ARB Air locker and I would put one in the front axle, and the rear-rear axle. They cost more up front, but will save you wear and tear on your entire drive train, and you can turn on em on only when needed, Also I've done several 200+ mile trips in the deuce at...

Hey Kaiser, were about in portland are ya located. and how much was that custom pyro :jumpin:

Well they are all the old style single large wheel. One of the 5 has the new style crank landing gear, and thats going to be used in front of my 30ft trailer im building.

2 of them are trashed, 2 should be in good shape. I'll look today and see.

Looking good. I'm planing on Rhinolining my entire bed and sides thi umme. I hope it wont effect the troop seat possitiong to bad.

I have the front half of 2 105 and 2 107 trailers. Going to the scrap yard, but I wanted to know if it worth saving the lunettes. Are they worth anything? All of the pins have a spot weld done to them so Id have to drill the pins out, wana know if its worth my time or not. Thanks.

Probably the best program I've seen about the F35 is Nova - Battle Of the X-Planes. About 2 hours, talks about the compation between Boeing and Lockheed Martin.

Didnt have time to take pictures. Working at a bar + st patricks day was crazy. Day like St. Paddy days make me wish I owned a large bar. We did over 17,000 in cover, and 65,000 in total sales(cover/food/booze). And I slept allday today, infact I didnt wake up until after the sunset, so I'll nab...

Still screaming its head off, and loving every minute of it.

Maybe, well see. Btw I unloaded my axles today and installed my troop seats right, and put on my bows.

Basicly what I'm going to install what is a T&P valve off a waterheater before in a T before the filters. If the back pressure gets to high, the valve will open, and bleed off into a second tank. I'm going to put a mechanical pressure gauge inline so I can see what the standard operating...

I just got finished making one of those SBC pumps. Im hooking it to a 1hp washer motor, 1750 rpm. We will see how it turns out tomorrow. I am going to put a blow off with a line running to a drum, so if the filter clogs, the Pressure release should open and prevent the lines from rupturing. I'll...

there is a picture of the APC turned into a limo

I think the frame width on the 5ton is the same as the deuce, if thats the case, the Curt 14082 should work in the width department.

When I drive my deuce to work, it goes from a 6 blocks drive, to a 3 mile drive so I can bring the truck up to temp, run around at temp for a lil, then when I get to work, I let it idle for about 10 minutes then I shut her down. Do the same thing on the way home.

I think thats the first multifuel'd 5ton I've seen on 1600's. Looks Great.

If I come up alone, your more then welcome to ride along with me Alex.

Looking good. Wish I could find a reason to rent an excavtor..I was thinking a moat, but I dont think the parents would go for that.

There must be a story behind this I must have missed.

M817s look much better with 1400's in my opinion.