Search results

Where did he live? I grew up in Augusta Ga.I live in North East about 18 miles south of Bristol,the world fastest half mile.Sorry to hear of your brother passing.

Welcome to the site,sounds like you are going to have a mean power wagon.Dwight

I called NAPA told them what I was looking for,(1/2 inch x 13 inches fuel hose for inside the tank for diesel). Said come on up they had it, was common on the bigger trucks.Looks pretty strong,will see what happen and how long of live it has.My old hose looked fine but while in to it mite as...

Thanks jluv I would rather have it tight to.I worked at a Jeep Dealer a lot of the 4 liters came from the factory with the fuel hose in the tank to short.The same design as the Deuce. Had a lot of no starts,pulled in with the hose srinked up pulled lose from the fuel supply housing.

Clinto I just thought I mite have a gasser,but thinking about it, they would not have a electic fuel pump. I could be wrong.I know it hard to remember,back last year Clinto.I just trust what you say,you have done a lot more on Deuce's than I have.Not trying to insult you.As papabear says,you a...

I think 7/16 will be easier to fine.Thanks jluv1185.Thight fit is always better than lose.

Has anyone else measured thiers?I pulled mine and it is 1/2 inch.Could mine have an odd ball in it? Clinto thought they were 3/4 inch.Anyone measure thiers?

Welcome to the site.

When I put a clutch,pressure plate and had the flywheel surfaced,the truck would not srart.Then I discovered the ground strap was off.Had to bolt it back to the engine,then started normal except for the trans was still out.

Welcome from East Tennessee.This truly is the best Green Iron site.I guess Tan Iron too.

Welcome to the site.

Thanks Mike I was just wondering.Thought if it was.then something I should replace.Thank again.Dwight

I guess without plactic,the machanic would be out of a job.Hope that will fix the problem.Do the Deuce use plactic impeler on the water pump?

I have set number OTC 7249,mite not be aluminum.Not steel,it is grayish color.Looks like cast aluminum,I could be wrong.

I tried about every brand.BluePoint and SnapOn was what I made a living with for 28 years,I did own about $40.000 of SnapOn tools,when you can't do the job because of broken or failed tools you lose money and sometime good customers.I hated the ujoint that have plastic.Heat it with a torch and...

Maybe the driveline put the trans in a bind,replace the bushions or arms then test drive.That mite fix eveything.

You should find a good motor.I hate you got a truck that the motor blew.Good looking truck,hope you find a good motor and get it changed out.Good luck.

Is that M715 in your avatar yours?Mite be a m725, not that knowable about them.Nice looking truck.

I looked at all the site, maybe I missed it. States Showroom Open,but seems to forget to tell you where it is.

Welcome from Tennessee.Just check around you should find a truck.Check the Classified Ads at the top.