Search results

Hey mobilauto2000, whats wrong with cleaning the tips?

Welcome from Fort Loxahatchee. That's in West Palm Beach, not too far north from you, exit 71 in I-95...

My scheduled M35A2 and M105A2 convoy to Punta Gorda was cut short just after 1.5 hours into the 4 hour drive because I noticed the clutch slipping. Glad I made back to the Fort. What is the best transmission jack to use on the Deuce?

Today I added engine oil, and drilled holes to install the remaining gradev 8 bolts and eye hooks in the bed to fasten my bomb crane, as I am going to pick up a 1000 pound gen set this saturday. Cant wait Who sells parts foe the 3KW gen set?

Hello another ahab, and yes,i tried to do that. I have 5 units that dont work and I tested them with my ohm meter and wrung out the wiring first with the controller apart,and then with the directional control all together. I figured out what pins on the control are switched with the movement on...

Installed my "repaired at home" directional control for my M35A2, and now I have both directionals and brake light!

Thought I could remove the 1/4" pins holding the hinges together, rather than remove the entire hinge from the cab fram, well I had a hard time getting some of the 1/4" pins put, out, and after heating the hinge too hot, I bent it all up. Had to use a reverse drill-out device to remove the 4...

I want to go !

Thank you frank8003, I have kept a record of these facts...I am ready to pick up an ME005 on my M105 trailer , nopefully this week from Punta Gorda..I amy pass by..look for my M35 with bomb crane haulling an M105...

Thank you bchauvette , I am so enjoying your rendition, and am reminded of a phrase so infrequently used these day...the art of driving...

Welcome from the badlands of South Florida, home of Fort Loxahatchee

What do you mean by THIRD MEMBER?

I opened the directional control (M35) and saw a board with wire soldered tomit, saw one wire not connected and soldered it, re installed but it still dont work. Are parts available for this?is there a diagram ? I got several that dont work and I want to fix them

Today I added fasteners to my bomb crane assembly. I did this because I am actually going to lift a ME005 gen set with it, and I used grade 8 , fine thread bolts and Gr. 8 flats, locks and nuts too. I dont think I have enough space to lift the gen onto the M35 bed, because of the space taken up...

Hello welldigger, and I am referring to the directional control mounted on the steering wheel. So I will attempt to clean it tomorrow. Once working, I am going to pick up an ME005 Gen set in Punta Gorda, which I will lift with my Bomb Crane. Wish me good tidings...

Copper crush gaskets are used on 1/4" gas pilot lines for natural gas appliances. They may have them in larger sizes too.

Continuing on Truck #1 ( M35A2 ) with no brake light, I pulled out the 2 wire electrical connector that attaches to the switch on the air pack ( conductor # 75, and 75. I depressed the brake pedal leaning a "B" acetylene tank over the pedal,and used my ohm meter sound device to determine...

Hello frank 8003,and this chart you provide is news to me, thank you very much

Going further with my magnetic starter install, I found the I have a "grounded" something once I connect the new batteries, and then I disconnected the plug going into the light switch, and, no more ground. I have now connected my batteries permanent, and and have power to my master switch...

is the faulty vent plug the only way for water to enter the axle?