Search results

Control box is SSI TECH 12469159-1 Glow plug controller is KDS 12469159-2

all original switches-no keyed switches. found the glow plug controller/tsu damaged. Wiggling it, and the electronics inside were easily exposed. Ordered the correct part that matches the control box. As soon as that gets installed, will run the engine again and test for voltage if it fails...

Batteries good. with Harness removed from temp sensor/glow plug controller….should I be able to start the vehicle? I removed harness from sensor, turned eng to run….proper wait light indications, and engine started. I thought it should just blink when I did that.

M998 6.2. Engine starts fine. Runs for 10-15min. Then sputters, and dies. Try to restart-light flashes, no clicks of the inj pump solenoid, no start. Let it cool down, get the proper clicks, wait light, etc, and starts-dies shortly thereafter…repeating the process. Come back next...

Thanks in advance: M1151a1. Standard lights, no led. Blinkers work with engine off. Turn signals work front and back, and might on turn signal switch blinks appropriately when engine is off. When I start the engine, turn signals don’t blink, and turn signal switch stays lit-no blinky...

Thank you, will give that a try

made the suggested tool. Tried to turn the fill plug. It’s locked up tight-bent my wrench. Any suggestions to get the fill plug loosened up? Heat?

Thank you so much. Bought it

Hoping to find just the plastic tank, not the whole unit

Thanks in advance…anyone know where to find the plastic tank/aftermarket part number to add to my master cylinder? A2 vehicle sn316xxx Would much rather spend $30 on a new tank than replace the whole unit.