Search results

$3.00 to $4.00 per loaded mile.

It is a single speed transfer case 1:1 ratio , it should have a 16 speed caterpiler transmission.

Spam

Does it have a low oil pressure shut off ? if it does I would check the sensor for it .

Not sure about a trade manual , but here is the technical manaul for a 101 from this site ; TM9-2330-202-14&P.pdf

You copy the pictures from the CL ad and post them directly on SS . When the ad gets deleted the picture will no longer be in this thread.

The -34P or -24P tm"s for the 900 series should have the info your looking for along with drawings. TM's for the 939 series trucks

Don't have page number , I used the search in the vehicles for sale forum , type in M36

There is one currently listed in the steelsodiers classifieds . Member Bob H had one with a winch for sale awhile back , you could try PM'ing him .

M818 5 ton Tractor Truck Horsepower: 225 bhp @ 2100 rpm Transmission: 5 spd. Manual Electrical System: 24 volt Tires: 11:00 x 20, 12 ply Brakes: Air over Hydraulic Fording: With kit: 78 inches/Without kit: 30 inches Approach Angle: 45 degrees Payload:15,000 lbs Towable...

Call your local chevy dealer and ask them how many flat-rate hours the job takes . Motor Manuals professional service trades edition has a flat-rate guide , but they are expensive and probably hard to find for a 30+ year old truck.

This is what the folding tongue is for .

:popcorn:

You can probably figure it out if you read this article by David Doyle ; Deciphering the codes: Kaiser-Jeep and AM ... - Military Trader click on blue text to open it .

You need to post some pictures to see what you have .

Because drivers licenses typically are good for 4 or 5 years , medical cards are only good for 2 or 3 . Plus some medical conditions still allow you to drive but require annual renewal of your medical card .

Jatonka M915 series TMs

Welcome . start with reading and downloading these TM'S ; TM9-2320-209-10-1.pdf GTA-9-1-1851-8.pdf

They probabley just replaced the hour meter , hours and miles don't mean much as the gauges get swapped out .

Vendor's forum there are some here