Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.
For the past while I have noticed oil all over the starter and from end of my deuce. To some time and pressured all the oil off and fired it up to see where the oil was coming from. After it ran for a while I got looking and there is oil coming from the exhaust side of the turbo where the...
Getting ready to put the output shaft bearing back in my transfer case and I'm trying to find out how much end play (in and out) the output shaft should have.
Was driving the deuce last night the parking brake got stuck on. Had to drive bout 2 miles in slow traffic till I found a place to pull off and mess with it. After I got it free it was fine at low speeds, but on my drive home I have a vibration coming from some where. I crawled under it today to...
I know that rotella oil is very good, but i am concerened about putting it in my deuce. I see that it calls for straight 30W. I didnt have a worry about running this in the summer when it is warm, but now it getting close to winter im goin to be driving it a good bit plowing snow and i was...
After putting the flywheel back on i put the indicator on the flywheel and turned the motor. In a few spots it made a clunking sound and mover about ten thousandths. I then put the indicator on the edge of the pilot bearing and rotated the plywheel again, once again the same noise and the same...
Took tranny out of my deuce last nite to replace the clutch witch i thought was slipping due to oil leaking from the rear main seal. I took it out and no oil from the rear seal. It is comin from the front of the tranny. I checked the tranny thining it was over filled but it wasn't. How do i go...
Looking for detailed measurments/pictures/instructions for a lift hoist for a m35a2. Can someone point me in the right direction. Im gonna build my own to save some money.
Im looking to put a plow on my Deuce. I am looking for ideas on how to mount it. It is a 11ft. plow. I have seen ppl. doing it on deuces without winches, but min has a winch.
I am wanting to install a 12 volt charging system on my m35a2. I figure you can use a 1 wire altenator. Was wondering if anyone could give some insite or pictures if you have done this.
Getting ready to install a new clutch. Need suggestion on what to do since this is my first deuce clutch install. Should I just do a clutch disc or the whole shabang? I also am going to replace the rear main while I'm in there. Also where can I get a alignment tool for the clutch? Where is a...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!