Search results

The hose routing of hydraulic pump is temp. i upgraded my fuel tank to 95 Gallons. The captured springs are original to chassis,my truck was former mobile command center, it was missing from chassis when i saw it on Iron Planet.

Operator error when i installed wire to battery. i got truck started with new pump

Problem resolved.

I'm now checking voltage at relay panel and x1 is 11v and x2 22v?

Battery was defective,i got issue corrected. The start issue i found is related to the oil pressure,with the start switch off the ol pressure is 14PSI and when switched off it climbs to 40PSI similarly to a fuel gauge.

Tomorrow i will recheck wires and take some photo. My apologies for the initial info dump on my initial post.

i'm not trying to confuse anyone in the forum,i know i threw a lot of info out on original post to ronmar. if i did screw up wire install does anyone have the setup. wires that go from battery to starter to isolator .

Both batteries voltage 12v when disconnected, i checked with FLUKE meter,when all wires are connected the side that's suppose to be 24v reading 3v. I don' think i hooked battery cables up wrong, i only Have 2 battery setup also no NATO plug or cables. it's the way i purchase vehicle

i checked voltage at the alternator leads, the lead atop the alternator the right one 12v and the other lead was 3v, its the same volts at the the battery isolator. all the way to the battery. my Alternator is 100A

Hi Ronmar. You recently gave some good advice on Youtube comments about the turn signal issues. The back story. Today i finished plumbing of fuel line and installing FASS Fuel pump and wiring. i went to start truck but nothing,the fuel solenoid doesn't click. i checked voltage at Alternator and...

I won auction LMTV 2/4/21 and EUC approved 4/14/21

Hi Chuck is that the S&S LWB in PA, Sent from my SM-N950U using Tapatalk

I appreciate that thanks. I'm in NJ ill use the XS Power 3400AGM Sent from my SM-N950U using Tapatalk

Im a nubie to site and I'm looking at M1085 LWD bu it needs batteries, i have access yo Group 34 AGM but doesn't know if they will work. And help out there on this. Thanks all.