Search results

Yah it was weird, the pin wasn't oversized. I did crimp it down a bit to make sure it doesn't rattle off. Gen works great now, first gen I have messed with. At least I know most of the components now, hopefully this thread helps someone.

Got it figured out guys, thanks for your help. Found these little guy disconnected while going through all my checks.

I got one of the issues addressed, engine not shutting off. The solenoid thumb knob was loose

Awesome info. I will follow through with these steps.

Ahhh I see!

I can not find that write-up for the mod.....

DC voltage reads fine, I can swap out a VR if this is a possibility. I have other sets I can "borrow" parts from.

The FU1 fuse is the one I checked and it is good.

Thank you so much, I am familiar with TMs. They are pretty vague and limited on diagnosing. Do you have a picture of the fuses? I have only noticed one fuse that sits below a circuit breaker. That fuse is intact

For troubleshooting, I have not done much for this symptom, since I am also dealing with not producing AC. After turning off the main switch and emergency switch it will take a couple of minutes to shut off. It will slowly idle down and stumble to turn off, like it is being starved fuel.

What was the outcome of this issue? I have the exact same problem.

Hello, I have an MEP-803A that I am currently working on. A bunch of issues, I am not too familiar with generators and need some assistance. #1 issue - Generator is not producing AC, no reading on AC gauge, reading 23-25 volts at terminals behind AC gauge, and convenience receptacles. Checked...

Yes, correct I am referring to the ICE diagnostic box. I was messing with it for the first time, I powered it up with the NATO cable option and it did no like it. I had a second one to use and that time with the 120v adapter. I learned my lesson

New to the forum, I have recently started to mess with this system. Yesterday to be specific, burned up the internals in the green ice box. If anybody here is familiar with the electrical boards inside and can guide me in the identification of burned up parts, that would be helpful. I have...