Search results

I just sold my m1008...loved it, would like to get another one. But I have this dilemma of should I get a CUCV II if they are even available. I saw one on ebay from california I think...about the end of april 09...it was real nice low miles minty..it went for around 5500 then. Any...

Ended up being a false alarm(maybe, I think), but I changed the thermostat out just in case. Now everything seems to work as it should.

That's the thing. I doesn't do it in the initial startup and high idle. When it kicks down...then the vibration starts. I have tighted the wingnuts and the skidplate for the tank does rattle once in a while. I am very appreciative for all your help.

I replaced one motor mount. Still debating on the next...passenger side...looks like a tight fit. But it looks good no metal on metal there. Incidentally I found out that they use small block engine mounts on these. Don't ask for the 6.2 or you'll find out later that you needed the small...

Again...yet another post to my vibration issue. As far is checking for a dead cylinder...you loosen the diesel feed tubes to the cylinder slowly and if there is not a change you have one? What about disconnecting the wire to the glow plug? Is this recommended? I would think that if you did...

Well my solid $2400 cucv is at it some more. I just got it a few weeks ago. Had some vibration issues and still do, but that's another thread. I am trying to figure out why neither hose from the radiator has pressure...I let it warm up for about 10 minutes and the hoses do not have any...

Okay...it's not the harmonic balancer...but it did need to be changed after I took it off it had some dry-rot and a couple chunks missing on the blockside. Nonetheless, didn't help. I did notice that the drivers side engine mount is actually touching the frame mount...on the rear side of the...

Check out the youtube video of the vibration viewed from the bed of the truck. I did a second video but it didn't upload. It was of a screwdriver lightly held by the rear with the tip bouncing popping up from the aircleaner while truck was running. I am going to go out and check around more...

Thanks for the reply. This is my first cucv and I am going to try and post a youtube video of the truck running. Also, I am going to try loosening the fuel lines individually to find out about a possible dead cylinder. Incidentally, the truck doesn't show any blow-by and seems to run out fine...

Hello all. I have a 86 m1008. I have a high humming resonance sound when at idle. The vibration can be felt mostly on the air cleaner and seems to be less in the front of the motor. When it is at idle the noise that resonates in the cab and in the box of the truck is super anoying. I have...