Search results

I ordered a fold and tumble rear bench seat for the m998 and it dosent fit at all. Does anyone have experience with a good rear bench/ center seat?? Thank you

I had the same issue with mine. I spent about 2 hours going through each connection and all grounds on mine this weekend. Turned the switch and BAM wait light works and volts draw down as intended. Your not far from me (im in Mooresville) if you where a little closer I would come by and give you...

Interesting. Mine is SN 060xxx (I can't remember the last 3 at the moment) and the delivery date was 03/89

My data plate has been replaced.

I ran an ohm test on the temp sensor and the wire feeding the gauge. on the 20k ohm setting I got a 10.5 which I believe is 10,000 ohms. I think im looking for under 2000 so im going to replace the temp sensor and see how that goes. As for the fan it is not free spinning when off so I think...

First picture is the plug for the tsu the metal sleeve in #3 slot looks deeper than the others to a point i dont believe it would be making contract with the prongs on the tsu Second picture is a wire that seems to lead to nowhere?

Pic to come of a 3rd wire going into the top manifold that is just capped... could this be a possible issue to this problem?

I would like to fix the temp gauge first.

Ive seen a lot of listing claiming gov rebuilds on there m998s. Are there specific tags/ plates/ markings on the motor and or body that would ID such a rebuild? I found an 11/11/14 on the air filter and the interior seems to be very fresh so I know someones put some work into it but im curious...

Just picked up an 89' m998 over the weekend. Ive been working through a lot of its issues with great success mostly due to the information on this forum but im finally stumped... Temp gauge is totally dead- I checked ohms to the wires into the gauge and im not getting anything. The fan runs all...