Search results

The hoist came out of a 1970 c60 chevy.

So far i have not been stoped. I only use the truck for personal use.

I don't know. I made these myself.

Here they are.

I will see about taking a pic and posting it for you.

I did have some problems to start with. I welded expanded metal to each one of the angles. Now it works great no slip at all, climbs up or down no problem.

anythingtruck.com

Try this http://www.bendixvrc.com/itemDisplay.asp?documentID=5091

The line from the compressor to tank remove from tank and put in on the in side of the dryer. Run a line from the out side of the dryer to the tank.

I have a bendix ad-9 installed on my duece. It hooks up to the air line from the compresser to the air tanks. Then you have to tee off the small line on the compresser and run a small line to the ad-9. Pic shows it on the outside of frame where the spare tire was.

The pto is from a deuce with the rear pto acc. The pump and drive shaft I had custom made by catco. All I used from the old dump was the hoist.

Had to lose the spare when I put the air dyer on. I don't travel to far from home most of the time.

You have to take the ramps off to use it as a dump.

I work at a hardare store by day. I did most of the work on the truck from 9 pm to 1 am at home took 2 months. Have a very understanding wife!

500 pounds ? skidsteer 6200

The ramps remove in about 15 min. Everything is pined on with quick cuplers on hyd

The ramps are 12 ft. two 6 ft frames made out of 2 1/2x3 3/16 thick tube 2x1/4" angle iron

I did all the work myself. I plow snow with my skidsteer and the salt in MN was getting to it on a open trailer. Thats what I bought it for. Had a 70 chev dump truck that was in bad shape so I took the hoist out and scraped the rest.

how much for cab artic heaters Multifuel

pump off rear facing pto in one of pics