Search results

Thanks! That's what I thought but just wanted to get confirmation. Yes, the hose is connected as you describe. Letting the blue gasket maker cure then I'll advance forward. Appreciate all the help!

When putting it back together does this need to stay open or closed?

What does this need in terms of lubricant if any?

These wires came off and I don't remember which went where. Does it matter when I go to reconnect them? Also on the gasket there should be two of these right? I'm looking at the diagram and its listed in the documentation as #15. Do I just pull hard to remove the metal piece that has the gasket...

Unfortunately I don't have time to wait for gaskets so here goes making my own. Hand tightened the screws and now letting it dry for 30 minutes. Will come back shortly to tighten. Update: The gasket set but letting it sit for 24 hours. Will update after its fully set. Need some help with where...

What is your opinion on changing out the gasket by making your own with this stuff...

I went ahead and cleaned it in the sand blaster. Came out looking great.

Also had a leak here. All my tools are too wide to fit in this area. Any suggestions for tool that is narrow and can fit here?

The water pump was leaking when it turned over so having to replace some gaskets including this one I cant find the part number.

Does anyone know what part number is this gasket?

Where did you source the weather resistant outlet from?

So the concrete pad is hardened and I plan to move the generator there soon.

Turned out great. Keeping it wet.

Ended up using stone as the base material and cut back the rods a bit.

Thank you! Yes I do need a vapor barrier of some kind. I'll get some plastic down!

I appreciate all of this feedback. Thank you for the replies and tips!

Here is the frame. All ready for concrete.

So basically the four 6x6 blocks that are bolted to the skid base are just sitting freely on the air compressor isolators? It wont vibrate off the slab and isolators when its in operation right? Its too heavy? So what your saying is there is absolutely no direct hardware that is put into the...

I'm building a concrete slab where the generator will sit. Do you guys bolt yours down to the concrete? How thick should I make the concrete slab?

What generator do you have set up for yours?