Search results

here is my 1967 drop side

awesome thank you

lugs are tight tie rods are questionable what and were is this king pin bushing (pic please)

Started noticing some front end shaking and popping while turning. So i jacked up the front end for a shake down to find that up and down is tight but left and right shaking has allot of play what could this be tie rods perhaps(have torn boots but i keep grease in them)

just got done testing the lines and cleaning the points in the switch works just fine thanks again for the help

awesome thank you guys for the help ill try this at the shop today

its just the left side front and rear. the right side works fine no hazards to

Driving home last night and the left turn signal started fading in and out the stopped working so i checked the bulbs they are fine now im at a loss any ideas what to check next?

I DD my M35A2C for almost a year through all weather all conditions and also took it trail riding on the weekends as well as downtown to some clubs and a few out of town trips hour to hour and a half one way. I still drive it about 80% of the time now but that will stop soon taking her off the...

Brent i live in Cary iv seen this truck many times in fact the tech at the dealer call me to find out how to add brake fluid and what kinda to use but dont worry all is good on the truck if you dont mind me asking how far did you talk them down from there sticker price

Same thing happened to the passenger side on my M35A2C turned out the bearing went bad outer bearing was almost gone causing the wheel to sit cocked like in the pic you provided. When i jacked my truck up the wheel fell off there was not enough bearing to hold it to the spindle and the inner...

I had same problem felt like a flat tire steering wheel shaking all the. Ended up being my bearings on the front were shot. Shake the front end left and right see if it moves.

Thank you all for the info i ended up using an air hammer an got it off an all put back together drives like a new truck

No the bearing seems to be stuck to the spindle

Ran into a wall while doing wheel bearings on my truck passenger side had no issue with but the driver side left me hanging. The driver side outer wheel bearing seems to be stuck on cannot get it off thus cannot remove drum or spindle. We tried pry bars and all that nothing not sure what i...