Search results

I have a 1997 H1 which is a 10.3 GVW. It needs both frame rails replaced. Im having a hard time finding 10.3k frame rails, but 12k seem plentiful. My question is what would I need to make 12k rails work on my truck. Or does anyone have leads on 10.3k rails

It all started when my front LH caliper was sticking on my 84 M1028 that I just bought. I figured it needed some lube, so I took it apart and grease it up and put it all back together. Just so were on the same page Ive owned like 6 of these trucks, so this isn't my first time working on one. Any...

nice find, just a heads up I'm in Albany NY don't know how far that is from you, but I have tons of little parts for that truck, if you need anything.

Snowed yesterday so I put her away for the winter.

http://www.gmsquarebody.com/forum/showthread.php?t=9868 This is my cummins swap build, it has some tid bits about the nv4500 swap hope some of it helps

Just wanted to give a final update on this problem I've been chasing for a few years now. Turns out it was the 37 military oz tires. Two different sets of tires and rims still the same vibration. Put a set of h2 rims with nitto tires truck drives amazing now . Thank you everyone here for all the...

I have them as well, if your man rick doesn't work out

You..... I know your doing a swap Just thought I would throw it out there maybe you need it

I have a nice 6.5 turbo intake with cover plate for sale if your interested

I have to agree with this, the more original these trucks are the higher the value

ok so here's an update. I am older and a lot smarter now. My truck has a 12v Cummins with a nv4500 5speed. I've have about 8k miles on the swap truck runs great. Problem is THE TRUCK STILL SHAKES. I cant figure it out. I put a custom built double CV drive shaft. So with the truck on jack stands...

Im pretty sure all 1ton trucks had jcodes

yup he drove it 20 miles with no water pump or alt.:lol:

does that work?

free image host I wouldn't say it was hard but overall there was a lot to do, from the nv4500 install to the cilivian wiring harness that I put in it was just a lot of work.

I have a 12v cummins in place of the 6.2

That could be exactly my problem, I will look into it hen I get home, thanks

how much slip was showing when it was to short? I just had my driveshaft cut down two inches and rebalanced because I installed a 12v cummins and nv4500

np208 Loose Slip Yoke I noticed a small amount of up and down play in my slip yoke of my 208, so I pulled the tailhousing and replaced the bearing/bushing/seal that's in there. Put it all back together and still a small amount a play. Found the U-joint to be bad, so I replaced that and still I...

the TC only has 30k on it, but the tailhousing is off of a different truck(thanks to GL) with 140k so I think I should just start by replacing the bearing/bushing/seal