Search results

Hey all, I just took some more detailed photos of the plates on the trailer.

Hey all, Just purchased this M1102 and it came with (what I believe to be) generator mounting platform. It’s some thick steel. I don’t have any need for it as I just need to use the trailer. Any cool ideas what to do with it? Is it something people sell or scrap? Thanks!

In!

I got a nice chunk of work done on my M54A1C this week. Changed the oil and oil filters, mounted the historical license plates both front and rear, confirmed the non-commerical registration, replaced the wiper motor (passenger), parking brake lever and cable, replaced the oil pressure sensor and...

I got it with primer included.

Just went to Home Depot and ordered FS 33446. I was in and out in 10 minutes. Here is the paint code label

I know this is old but what was your solution?

Thanks for that information. I got all the filters and cleaned her out good!

My truck is a M54A1C with an ENDT-673. Just about to order and change them for the first time and I wanted to verify some engine filter numbers to see if I got them correctly. Primary fuel filter (left from gasser) - NAPA 3080 (wix #33080) Secondary fuel filter - NAPA 3090 (wix #33234) Main...

So the wiper motor inlet is not letting air into the piston. Now the inlet part ( circled in red) has that piece of plastic that should be able to be pushed in to manually stop the air flow, but in this case it is stuck inwards permanently. That piece comes off the main piston with 6 screws and...

Do you have the hand brake, wiper air motor, and air cleaner?

I need to replace the oil pressure sensor and I'm trying to look for the that part. I think I have the correct part at Memphis Equipment: http://www.memphisequipment.com/PartsDetail.aspx?id=10000595 Any suggestions?

That is exactly what I will do. Thanks once again, AMGeneral.

Does that fit the M54A1C housing? Does it look different?

I believe that it is called the air housing cover. But I am missing one on my M54A1C and want to know if everyone knows where or who has one? Thanks

Hello everyone, So after a month of reading and drooling over all the toys on this site I have officially bit the bullet and got myself a toy of my own! Here are some pictures of my "new" 1972 Mack M54A1C with Mack ENDT-673 engine coming home today! It has some rust under the doors and decking...

NY CDL Requirements So with 5 ton trucks with 3 axles, does NY require that the driver have a CDL? I know its less then the GVWR of 26,001lbs. I've been told different answers.

Hi all! Another newbie here. I'm looking to buy my first military surplus ride. I'm leaning toward an M54a1c because someone reAlly close by has one for sale but I see many people on here with m35's and not too many m54's (could be wrong.) So are there any cons of the m54 at all? Better yet...