Search results

Any body has doors and windshield for these? Mike

would you recommend using Napa 6 rebuild kit for the rear calipers? Mike

Thank you every body for your help. How do you test oil pressure sender and the water temperature sender and corresponding guages. Does any body have wiring diagram for the two units. Mike

Does any one have a picture of where the temp. sender is located and how do you check oil pressure sender or what is the Napa replacement part number for oil pressure sender? Thank you Mike

Those are the best pictures I could get out of 15 shots, I will try again. It has a single point Mike

Here are couple of pictures I made, any suggestions?

Thank you, I will take a look and post it. Also would you happen to know the firing order of the flat head cylinders? Thank you again Mike

I have 1954 M37 that has been converted by some one and I need to get new distributor cap and rotor for it. It still has flat head six engine with 12 v distributor and non resistor 12 v coil. I am trying to replace cap and rotor, but have no way of knowing what Napa part numbers to use. Please...

Any pictures?

Is your gas tank in good shape, my tank has rust inside and pick up tube had rusted apart as well. What kind of roof you have and what shape it is in? Mike

Thank you, this is what I was looking for Mike

Looking for oil filter part number from Napa or any other oil filter brands, also looking for part number for radiator cap and fuel filter. I am going to try to start it up this weekend Thank you in advance.

Thank you to all of you, the plate has M56 W/WM on it and the coil has 12 volts on it so it looks like it was converted to 12 volt system. The top roof part is badly rusted up, is there any out there that can be purchased in good shape or reproduction steel roof panel. Thank you again mIKE

Thank you, I will check alternator first, that should give me information I need to know. Thank you for all the help. Mike :-P

Thank you Carter, there is no plate on the starter and starting is done by pushing a rod in the floor board which contacts a switch on to of the starter. Thank you Mike

Thank you Carter, it has a distributor with coil outside and the coil is just connected with spark plug type wire and it is not even bolted down. So would you think this truck is 12 v conversion, it also does not have generator and regulator individually, but it has alternator with positive and...

Thank you for the additional links, any thought if it will be OK to try 24 volts to start it with? Mike

Thank you all for replies, I will check out the links provided, could not find a link to ( AB Lynn ) If any body has it please post. I am getting ready to starting it and the batteries did not come with the truck, so I was not sure if I will need single 12 volt or dual for 24V. This truck was...

New to 1954 M37 that I purchased from Oklahoma forestry and have many questions. First did they all come with 24 v or 12 v system? Second question, where do I get part and service manual? What are the best places to purchase replacement parts for M37? Thank you for any and all help in advance...

test