Search results

Thank you Capehenery

Thank you T.Highway and Nchittendon

Thank you Neophyte

I figured out my problem with trying to remove hub from spindle, I had to overcome the air and oil seals in the hub came off. Now I need to check the rest.

Hi Porkysplace, I think Artisan was trying another way to get me help. No I need to check the rest.I figured out my problem with trying to remove hub from spindle, I had to overcome the air and oil seals in the hub and it came off.

Hi Another Ahab, Thanks for the welcome. I just need to figure this out before putting a real load behind it. I already went thru the trailer with new bearings.

Hi Artisan, The brake for the wheel is caged. The drum is off. Equipment ConditionFront wheels chocked. (TM 9-2320-272-10) Spring brake caged. (TM 9-2320-272-10) Rear wheel(s) removed. (TM 9-2320-272-10)

Hi Artisan, Thanks for response. I have FIELD MAINTENANCEREAR HUBS REPLACEMENT (M939A2) TM 9-2320-272-23-3 work package page 0482 I think its just the air seals holding but not sure.

Hi all, I have this in the new member section to. thanks for the help I have a question that I hope to be answered. The right rear-rear axle shaft was leaking at the flange and after pulling the shaft the outer bearing has no grease on it but differential oil covering it. Is this correct...

Hi All, I purchased a 931A2 in early August have been working it since. I have a 10 ton goose neck dump trailer hooked up to it and have hauled 2 loads of scrap tires weighting in at 2.5 and 1.8 tons that the truck probably did not even know a trailer was hooked up. I have installed a 12 volt...