Search results

has any one used synthetic gear oil or something other than mill spec and if so what ?

i am still dealing with transmission errors and after some research it looks like they used a Controler out of a m1088 in my m1078 so i need to reprogram it. do any of you have the CIN# of your wtec II controller its a programming # normally on the side next to the part # the problem is the...

still looking for an actuator on the driver side its stamped with TAGA on it. i have the part number from the TM but haven't had any luck finding one. Any ideas or help would be great PN 12417475 (driver I think) 12417476 (passenger I think) i only need the driver one

i have a bad solenoid so i have to pull the oil pan and valve body. has anyone done this and if so did you have to pull the yoke off the front of the transfer case so it would clear ?

2123=Throttle position sensor, failed high I have done the adjustment and still no go is there a way to rebuild the sensor? I am also getting a 4413= Short-to-ground, B solenoid circuit witch is inside the trans so i will find someone to fix that one I don't want to crack the trans open.

i need the door handle cutout dimensions i am at a yard looking at some Kenworth door handles as a solution but i lost my paper with dimensions.

Chapel Hill

Just got a 1078 from Georgia and it has 2 antenna mounts and a load of radio cable. I will get pics up later this week after I unbolt the brackets. PS: To the guys that picked up the van today at Fort Stewart you have to tell me if it made the drive, ok?