Search results

Can anyone tell me where to find the vin# on a 1980 m916. The data plate is missing and I can not find the number anywhere else on the truck? I am trying to file my sf97.

titles - vin# Can anyone tell me where to find the vin# on an 1980 M916 that is missing its data plate. I'm trying to order a SF97 and can not find it anywhere.

Thanks, looks like the regulator is bad. I'll try your advice on finding a replacement.

My mep002a is running at max voltage all the time. Showing 130 volts or 300 based on setting. Any ideas?

Can I connect two MEP002's to double the amps? I need 100 amps @110 to run a powder coating system.

great, thanks

Ft drum Are the Gov Liquidation folks at Ft Drum capable of helping with load out? I have 3 mep002's to pick-up but no easy way to get them onto my flatbed. Anyone have experience there?

The wires running to the brushes in the starter housing has come off, not sure if someone had improperly hooked up batteries and burned them off?? I soldered them back in place reassembled, cleaned all the contacts, remounted the starter, and viola!!! This was not a cheap unit but it is in...

She roared to life about 20 mins ago. Thanks for all the help!

Just pulled the starter and I am cleaning all the contacts. Any way to test it while I have it off the engine?

If I need a new starter does anyone have a source?

After going through the TM my starter failed the field coil short/ground test. Is this repairable? I didn't see a direct link to procedure once the unit fails this test.

Thanks all, found the manual in the resource section. Should be able to find a solution there.

Recetly picked up a MEP 003. No luck getting it to roll over. Only has 4xx hours on it and appears to be complete. I have 2 new 12v batteries (600 cranking amps) hooked up to make 24v just as the diagram shows. Panel light illuminates, fuel pump runs, intake heats up, but won't roll over...