Search results

Out shooting with friends

Fun shoot with friends

The Correct answer is ,,,, Maybe. you would likely want to wash the old grease out and put new in and if it is a sealed bearing that comes with complications like the seals.

Heck the wallered out alternator pulley on my 200A sounded like a knock, I knew it wasn't but it sure banged around.

Might run a compresson test on it too. can reveal a lot. sometimes stuck valves or bent pushrods... can result in odd noises that sound like a knock.

A Little While back I added A/C to my 1097R1 Red Dot Evaporator, Sanden 508 Compressor with 24VDC Clutch, BlackDog Customs Compressor Bracket, Red Dot 5 groove water pump pulley. bunch of hose and fittings and a parallel flow condenser from Coldmaster, and a simple wiring harness. works quite...

They Finally published the photos from the car show at LCAAP, WE are not allowed to take pics... but certain people can then they have to be approved for release... Anyway here is the photo of my 1097R1 from the show day First Place... this was in May...

Creamy or gray oil?

I'd do a compression check and or Leakage check on that cylinder and see if the adjacent cylinder has the same issue. Hope it didn't hydraulic lock...

Apply 24VDC to the clutch coil and see if it clicks in. if not it could be a bad clutch. Check the High/Low pressure switches. Check the Temp Switch... all of these are bypassable.

Updates, the fuel mileage reduced from 13MPG to 12MPG... The Temp on an Extreme hot day has increased 10 degrees from 180 to 190... this is with the two wire connector disconnected. sitting still in traffic does cause the temp to increase a little bit.

It is a Chromate coating. Zinc Chromate

Remove Valve Core, Remove NUTS, at this point you can support the wheel face on a bucket if you want or something then use a prybar to get the wheel face off the assembly. recover your O-Ring and don't STRETCH it, Unlikely to find a vendor in Town with the O-Ring or O-ring Stock... Runflat is...

by the guys with this truck...

Designed and printed a couple duct transitions. Printed from ASA. Now I get 41 degree air blowing on my head.

PRC-77 and PRC-126.. Have since added anAN/4979-A Loudspeaker. I have a 6747 that is brand new that I plan to swap in place of the 4979 that is kinda beat up. and a Diplexer so I can run 3 Radios off two antennas in the same Frequency range. I do have a Harris Antenna that I can also run a UHF...

Kudos to Coldmaster for backing their product. I sent pic of the broken housing the tech asked for a pic of the wiring and immediately shipped out the proper replacement part, UPS Ground so had in hand in exactly 4 days from florida.

New EXACT match blower assembly received and installed so now I have all 3 speeds. Low Mid Hi... Here are a few pics of the damage due to the broken housing and the place where the squirrel cage burned through the housing.

I recall a sony Boom Box Bungeed to the dash.... Interestingly we were Comm oriented and did not have radios installed in our HMMWVs, they were in a couple rucks. an LST-5B and a PRC-113 and their attendant Comsec gear, a little DMSE satcom antenna and a Donkey Dick on the 113. Back then we...

Kept having to explain the direction arrows when installing... and "This Side Up"