Search results

could anyone tell me if this is an evens fan clutch i need to rebuild it and saw a kit on eastern surplus and want to make sure im getting the right one?

does anyone have a diagram for the fuel tank. for the life of me i can find it in the tm. i need to know what the pick-up tube goes in to at the bottom of the tank.

I've change both fuel filters on m m923a2 before with no issue. this time i removed the tank and cleaned all the gunk out before changer the filters. i topped off both filters and pumped till fuel came out of the bleed screw. truck started and ran fine for a few minutes then died. i...

My fan actuator is leaking air from the smaller hole on the end cap. i cleaned and lubed it but still leaks air. i was wondering if it should have an o ring. it did not have one when i took the cap off?

forgive my ignorance - what engine oil weight do i use for my 923a2?

my m923a2 had air escaping from the air dyer took it apart and decided not to rebuild just replace. replaced and all was fine for a few mile and it started leaking out of the same blow out valve. i am at a loss any ideas out there? i used a punch to press the valve closed a virew time...

the last couple time a started the truck, it took a long time to air up. The last time it would not air up past about 25 and now not at all. I soaped everthing i could with soap but no luck. i replace the governor and did a complete service/rebuild on the air dryer. Still would not air...

Can anyone help me finding the part # for the #6 tank drain hose. for the life of me i cant find it. this is the line that runs from the air tank on the drivers side to the #2 or bottom drain valves on the pass. side. thanks ....mike

just stated to hear a low clunking/rattling noise at the front of my 5 tons engine. i can only hear it when its idling. Could this be the fan clutch or vibration dampener going bad?? Any ideas??