Search results

Aftermarket fuel/water separators lacks the drain hose on the bottom which can make a mess inside your unit when you do drain water. With two needle valves, a cap, some fuel line and clamps you can rig one together. You'll need two 1/4in OD X 1/8in MIP angle needle valves and a 1/4in OD...

As the title says I have an injector pump leaking fuel. I've ripped the whole thing apart, cleaned it and replaced the o-ring on the high pressure side. I double checked the fuel line and when I put in all back together today I replaced the hose clamp with a new crimp clamp on the low pressure...

Alright I need to some help before I lose my mind. The WIX 51374 oil filter, I pulled the old one off and the new one won't go on. It feels like it's a different thread pattern. I've checked, both oil filters have the same number and both are the same size. The only difference I can find...

Anyone have a source on a oil pressure gauge for an 802/803? The oil pressure gauge on my 803 died and I've been looking for one. I found the thread with the datcon part numbers but searching the internet has only led me to 12v versions. Any help would be much appreciated. OH and I'll throw...

Hello everyone I've been kinda dragging my feet on getting pictures up but here they are. So I ran 1.25 inch conduit, the run was about 50 to 60 feet long to get from the back of the house to the side of the house. I bought one long run of 250ft of 6 gauge wire for my two hots and neutral...

Looking for recommendations on a Auxiliary tank under 50 gallons that will be stored outside in Pennsylvania. It will be under a deck so not totally in the elements... It's for a 803. Thanks everyone

I'm in the process of wrapping up my install. Between a electrician friend and a lot of reading on NEC code I felt comfortable doing a lot of the "manual leg work" like digging the trench, laying conduit, pulling 6awg thwn rated at 65 amps, pouring a concrete pad for my 803. All I have left is...

My mep-803a was delivered today. After cleaning it up a little and doing a inspection I came across these guys. I've never seen them on a unit before. I put it on casters and installed new AGM batteries. It started right up and ran perfectly. Only had a chance to check the convenience outlets...

Hello all, I was the lucky winner of a 803a in today's auction. I've been lurking for awhile but finally decided to make a profile. I'm a ARMY vet, 2003 through 08 as an air traffic controller (mos 93C / 15Q). Did a year in Korea and two deployments to Iraq with the 101st, ETS'd and got a job...