Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.
I got it out of the manual by Quincy page 2-1482.16 , I think it was in second one down there is a section in there that reads WTEC 2 ecu pushbutton shift selector does not illuminate so I went through that. Says disconnect P116 from Vim, then check ohms at J1 to R1 and states if continuity is...
I went through and found proper diagnostics for wtec2 not illuminating. It asks to check Vim J1 and J2 which I did. They ask for 12 volt reading at those points and mine is 24 volt vim? Also someone has power from fuse panel CB20 not CB35 like it says! So regardless I had voltage so I kept...
Thanks Ronmar
If I turn off green switch, then I check from battery neg to neg at power panel they should have common reading with between 0.00-1 ohm correct?. Sounds like I have a bad Wtec2 trans controller. Where and how much?? I still would love a proper schematic or diagnosis on this wtec2...
I have 3116 I think? I paid 1,500 bucks for it. Its in great shape, starts and runs fine. It was driving before? owner died 35 years old. pipe line worker.
I found it on this sight M1078 there was 8 of them. It was third one down. TM M1078 listed f40 WTECH transmission push button selector does not illuminate. .... so I followed steps the fuse 43 and 79 check was the same, but once it got deeper they have different pin outs on the VIM they show a...
Unit can be jumped at starter relay, but will not start at bush button, Also no lights at Alllison display panel. The head lights work horn works?I have 24 and 12 volts in fuse panel as well. so when I opened up VIM the fuses both have 24 volts. When you plug in main fuse I see cats eyes on...
I wanted to thank you! your response is great. You know your stuff and your message is going to help me a lot once I get this thing home.I hope these are good trucks. Sure is hard start cold not even freezing yet. Ill get my multi meter and diagnose this thing. Once I get this thing figured...
I need to find ground sources
i pulled the fuse panel right out so I can see the back. There looks to only one fuse related to transmission and its not labeled transmission on the back of the fuse panel cover. I follow the wire down to the Allison module, looks like they feed 24 volts into...
Got a bit further today.
Ok I checked the lugs on fuse panel. The 24 volt read 27volts with switch on and truck running, the 12 volt was reading 13volts so all looks good there. Power seems to be coming in to fuses but the only light I could get to work are hazards,and heater. I found the...
It’s a 1994 Stewart Stevenson sn# NH00VZV0282BLB
I hope that helps I’m not sure AO A1? ,thanks so much for the info you guys are great! I’m sure I can track something down, maybe a mouse in there 😊
Got good ground
I added the nato ground so I show good ground. As soon as I flick the green switch I hear a tick tick tick. Its a deeper sound than the bosh relays make. It does not like something? It gives me about 2-3 seconds of start time then shuts starter down. Thats when I bypassed...
I have a M1079 that would not start? It would try if I let it sit for 15 seconds, but every time I turn the power switch on I get the low air siren ,and a clicking sound under fuse panel somewhere? Its almost like a breaker is triggered due to high amp draw. I hear a click on/off on/off. The...