Search results

Sorry didn't take pictures of it apart. If you want I could take pictures of it back together but it wouldn't look any different from your guys trucks. But I will say trying to lift that driveshaft up by myself while bolting it in was difficult. That thing is HEAVY! At some point I will pressure...

I know the maxi's are the main parking brake its just the springs in the parking brake were dragging and clunking and that was my problem. Today I finally finished putting everything back together. Put the new seal in and new springs and torqued down the new bolt. I took it for a test drive and...

So yesterday I was able to replace the seal on the input shaft to the transfer case. Trying to get the bolts out that hold the u-joint was a pain. I t was hard to keep it from spinning but finally I got it. I went to go get some new seals for the transfer but they only had 1 in stock. The other...

I was planning on using the nut again just with locktight. Is this suggested or not?

I went to napa to day and ordered the spring. 5-7 business days:( Oh well, while I wait for the spring I guess Im going to replace the oil seals on the transfer case since they are leaking a little. The trans to transfer seal and the rear output seal are the ones that are leaking. I assume it...

Ok so today I dropped the drive shaft to get to the parking brake and I will say that thing is heavy! I got the bolt off and then used a puller to get that other part off. I took the drum off and sure enough there was a loose spring in there or should I say the remanants of a spring. I took...

Will do!

I have tested the parking brake but it seemed that whenever I would try to tighten the knob it would hold the truck but in any position the the handle was in. Even if I tried disengaging the parking brake I would hear and feel a little drag in the brake. I have tried adjusting it alot but it...

Ok so I checked out the truck including all the fluids, and they all seemed fine. No metal shavings which is good! I checked the bell housing which had not moved and I checked the driveshafts for play. All seemed fine. The only other thing I could think it may be would be the parking brake...

I will check on that. Would the bell housings backing out cause binding up just going slow and not moving fast?

Well today I was driving my m923 around and as I was starting to drive away it slowly stopped and clunked. It felt like something was binding up. I put it in neutral got out of the truck to see it I ran over something but there was nothing. I got back in, put it in drive, released the brakes and...